AL-E1415 INDUCTION MOTOR FAULT-FINDING TRAINER
Project Information
- Category: ELECTRICAL ENGINEERING
- Sub Category: ELECTRICAL ENGINEERING
- Model Number: AL-E1415
Description
AL-E1415 INDUCTION MOTOR FAULT-FINDING
TRAINER
ReferenceAL-E1415
· Equipment: Didactic fault-finding trainer for practical diagnosis of faults in a three-phase cage induction motor with brake.
· Motor: Three-phase squirrel-cage/asynchronous induction motor coupled to a suitable mechanical/electromagnetic brake.
· Fault Simulation: Controlled simulation of common motor winding faults, including:
o Winding open circuit / phase cut
o Winding damage or partial winding fault
o Inter-turn/turn-to-turn short circuit
o Winding short circuit to earth/ground
· Fault Selection: Clearly identified and safely accessible fault-selection controls for creating individual fault conditions.
· Measurement: Test points and measuring facilities for phase voltage, current, continuity, resistance and other relevant motor parameters.
· Diagnostic Tests: Provision for performing electrical measurements and safety/insulation tests to identify simulated faults.
· Insulation Testing: Suitable insulation-resistance testing facility or interface for use with an insulation tester/megohmmeter.
· Motor Connections: Clearly labelled motor terminals with suitable connection arrangements for practical testing.
· Brake System: Brake control facility for studying motor operation under controlled load conditions.
· Training Applications: Fault identification, measurement-based diagnosis, winding testing, insulation testing and troubleshooting procedures.
· Safety: Emergency stop, circuit protection, electrical isolation, protected fault-simulation circuitry and safe-access test terminals.
· Construction: Robust modular aluminium-frame training system suitable for repeated laboratory use.
· Accessories: Required motor, brake, fault-simulation circuitry, test leads, measurement accessories and safety equipment.
· Documentation: Detailed experiment manual, wiring diagrams, fault-diagnosis procedures, test procedures and safety instructions.
· Supplier shall confirm: Exact manufacturer/model; catalogue/custom status; point-by-point compliance; complete BOM and accessories; dimensions, weight, utilities and interfaces; drawings; safety certificates; capacity/test evidence; delivery and site-support schedule; assumptions and exclusions.